It's TOTAL CARNAGE in western Pa.!!

[TOTAL CARNAGE]

Well, no it's not. It;s just me...Dan. Using the name I picked up during my racing years.
Just wanted to say hi, tell you all what a great site this is. Good info and hot bikes!
Thanks to this site I just found out I own a Spaceliner!! How cool is that?
Here are some of my bikes.

 

[Rat Rod]

Welcome aboard....you should fit right in. :wink:

 

[maddogrider]

Welcome, can ya show us how you got the motor sprocket on your coster brake hub for your Schwinn motor bike? I have a motor for one of my bikes but the i am hving a problem with the coaster brake. Nice collection.

 

[TOTAL CARNAGE]

Thank you Rat Rod. Nice place!
maddogrider....I removed the brake arm and bent it to clear the bolts. No heat just a big vise and hammer. Just under the arm is the dust shield. I use it to scribe the center hole on the sprocket and use a burr bit on high speed in the drill press to open it up until it fits over the shield. last, I used a dremel tool with sanding drum to taper the rubber ring that fits between the sprocket and spokes (rays?) so it sets in tighter with the bell facing out. No mod is needed to the inside ring.
Hope this helps.

 

[maddogrider]

Cool thanks Carnage that is just what i needed 8)

 

[Markm]

welcome :mrgreen:

 

[HotRodJen]

welcome aboard nice bikes!