I wasn't going to get in on this but I can't help myself. I had started a build with this frame but decided to go a different direction, so I hope that counts as a fresh start.
This is where I was as of the start of the build.
3 days ago I decided to add the board to the frame
Then I finally got my trike donor for 20 bucks!!!
Took everything apart, cleaned it up and put it back together for mock ups.
Since I'm going to keep the bent springer on the front I can't use a front brake, so I've decided to integrate a disk brake on the rear axle. Got the rotor and caliper on order and should have em next week! It's going to have a wood bed on the back with an audio system and a bit more. Having a hard time deciding if I want to go 26" all around or 26" in the front and keep the 24"s on the back. I'm not going to do a drawing to show what it's going to look like in the end because it'll probably change a bunch of times before then.
This is where I was as of the start of the build.
3 days ago I decided to add the board to the frame
Then I finally got my trike donor for 20 bucks!!!
Took everything apart, cleaned it up and put it back together for mock ups.
Since I'm going to keep the bent springer on the front I can't use a front brake, so I've decided to integrate a disk brake on the rear axle. Got the rotor and caliper on order and should have em next week! It's going to have a wood bed on the back with an audio system and a bit more. Having a hard time deciding if I want to go 26" all around or 26" in the front and keep the 24"s on the back. I'm not going to do a drawing to show what it's going to look like in the end because it'll probably change a bunch of times before then.