I'm on a few forums - as most of us are, and a fun little thread that is always active is the "what did you do to your _______ today" . So if you dont want to post a thread about about the full build of your bike, post your small projects that you did today!
so today I removed the wheel discs from my RRBO bike and put them on my motorbike - big deal huh? well, i had to cut out a larger hole for the "drive" sprocket, then i had to re-mount the motor sprocket - not an easy job, that combined with a high of 98 - i was a man on a mission.
I removed the discs from this bike - I think i like it a bit more without them
the front is a breeze to install - but the back - thats a different story - the black wheel in the back is just a place holder
i needed to cut out a larger hole - i made up a scribe using a paper clip and pencil to get the radius just right - then i cut in from the center with scissors..
and used a #11 exacto to score the pieces out of it to get a nice clean line.
then 2 hours of struggling with a silly china sprocket - and here is the end result
so the question is - what did you guys do today?
so today I removed the wheel discs from my RRBO bike and put them on my motorbike - big deal huh? well, i had to cut out a larger hole for the "drive" sprocket, then i had to re-mount the motor sprocket - not an easy job, that combined with a high of 98 - i was a man on a mission.
I removed the discs from this bike - I think i like it a bit more without them
the front is a breeze to install - but the back - thats a different story - the black wheel in the back is just a place holder
i needed to cut out a larger hole - i made up a scribe using a paper clip and pencil to get the radius just right - then i cut in from the center with scissors..
and used a #11 exacto to score the pieces out of it to get a nice clean line.
then 2 hours of struggling with a silly china sprocket - and here is the end result
so the question is - what did you guys do today?