Spaceliner rat trap fork

Rat Rod Bikes Bicycle Forum

Help Support Rat Rod Bikes Bicycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Nov 21, 2009
Messages
54
Reaction score
15
Location
Poland, Chicago
Rating - 0%
0   0   0
I want to paint my spaceliner springer fork,I wanted to disassemble it first, but I have no clue how to remove a spring, is it possible? has anyone here done it before? :39:
 
You have to take one of the caps off the end of the bar that runs through the spring and frame of the fork. Then you need something like a screwdriver to drive out the pin. There is tension on the spring. When you put it back together it is much harder to do without scratching the paint. You put the spring in the cut out in the fork and put the bar back through the frame of the fork and spring. It will go about a 1/4 of the way in and get stuck on a angle. You need to pull the spring forward toward the front of the fork and down to line up the other frame hole. I do this with small bar clamps with rubber ends. Then you can tap the bar through the spring and fork frame hole then recap it. I have a rat trap fork apart I can take some pics in the morning to show you how it is done.
 
Was there any photos of this ever taken? I'm in the process of wanting to get my fork redone...

Sent from my XT1575 using Tapatalk
 
Thanks I have one also & considered try this too [emoji1303]


Sent from my iPhone using Tapatalk
 
Thanks I have one also & considered try this too [emoji1303]


Sent from my iPhone using Tapatalk
its been a year , i don't think he will post the pics :(
 
Here are some pics and how to take the Rat Trap fork apart and put it back together. This is the same for the Spaceliner, Screamer, Eliminator rat trap forks.

First pry the cap off the end of the bar holding the spring to the frame.





Then use a hammer to drive the pin out.



Tap the pin back through spring to get it out and you are done. That is the Easy part.



Now to install the spring in a freshly painted fork and Not break the paint is hard to do. You should practice on the fork before you paint it about 5 times at least. It works best with 2 people. Here are the tools I use.



OK here we go. First put that V bend in the spring through the frame. The spring can move around some so the bolt can go through the center of the spring to the other side.







As you can see the bolt needs to come forward and down to center in the other side frame hole. This is where you use the clamps. One to bring it forward and one to bring it down. I bring it forward first.


Then one clamp to bring it down.




Almost there now. Here is where a second person helps out. You can twist/bend the clamps to move to bolt to line up perfect. Then the other person taps the bolt through while you hold it. I used a bearing cup to help push the spring down. Either way will work.









Put the end caps back on. The original chrome dome caps I could not find. The cap shown is a cheap looking cap. You can find caps a Home Depot that look nice.




Here is a pic of the end caps from Home Depot. I installed the spring on this painted fork with no paint lose.




Sorry for the LONG delay in posting the pics. Hope the info helps.
 
Well it's about time my bike has been on hold until now ! Just kidding yours looks great love the old school color .
Thanks


Sent from my iPhone using Tapatalk
 

Latest posts

Back
Top