- Joined
- Jun 5, 2012
- Messages
- 558
- Reaction score
- 1,752
I know this sounds like it should be a simple answer but while doing some brainstorming for my build off bike i originally considered using a 24" rat trap springer that i acquired for cheap
However I decided I wanted a lower stance so i figured a 20" would work better
When I went to buy one that was listed as a 20" i noticed it was the same as my 24"
later I checked with a member on here that had a 20" ant it also had the same measurements
So does any one know if there is a difference in size between a 20" and 24" or are they in fact the same
If no one knows for sure i have the measurement of a 26" and my 24" and i would like to get some other measurements from members with either 24" as well as 20"
I measured from the top bolt where the truss connects to the bolt where the rocker arms connect to the fork (see picture)
26" rat trap = approximately 14"
24" rat trap = approximately 12"
However I decided I wanted a lower stance so i figured a 20" would work better
When I went to buy one that was listed as a 20" i noticed it was the same as my 24"
later I checked with a member on here that had a 20" ant it also had the same measurements
So does any one know if there is a difference in size between a 20" and 24" or are they in fact the same
If no one knows for sure i have the measurement of a 26" and my 24" and i would like to get some other measurements from members with either 24" as well as 20"
I measured from the top bolt where the truss connects to the bolt where the rocker arms connect to the fork (see picture)
26" rat trap = approximately 14"
24" rat trap = approximately 12"
