Search results

Thanks so much guys. I think I am headed in the right direction. Should be able to try #10 over the weekend. Thanks again, BC

Hey, Question ?? I have taken apart the "Model D" hub, cleaned, rebuilt, greased, and assembled it. Once I have the axle shaft in and set where it will rotate freely, I them try to re-install it in the frame and the axle shaft becomes loose and sloppy. What am I doing wrong ?? Did I not...

Slow but sure....I managed to finish lacing and truing the wheel yesterday. I also took my car for a little drive in the snow too.. http://www.youtube.com/watch?v=emh7uNiaJ7M Best, BC

Managed to get back out and work on it some more. Welded the fork brace, just need to clean up the welds. Check out the mini rockers I made. Thanks for looking, BC in KC

Hey, I actually had some time this weekend to work on the bike. Managed to bob the rear fender and move the brace to a vertical position like the HD peashooters. Also cut and welded the seat post so it would lower and move the seat to the rear. Managed to get the seat frame separate from the...

Well I did it. I bought an old Columbia off of craigslist. Plan is to get it going under pedal power, then maybe put an 80cc engine on it. Any comments or suggestions are welcome. Until the nets are full, BC in KC

After posting a request about bike swap meets and shops in KC, I was told I needed to post an intro. Here goes !!! Car guy all of my life. Had many different bikes as a kid. Still ride a road bike for exercise. Have a hobby and small business building scale models http://www.bcmmodels.com...

Hey to all. Question for the guys in KC. Are there any bike junk yards or shops that sell used parts ?? When might the next swap meet be and where ?? Starting the search for a few parts for possible projects. Many thanks in advance, BC