Frankly I wish they dropouts were a bit over 3/8" but they are very close to 1/2 inch and appear to be consistent in that measurement with little to no wear points.
Frustrated with any reasonable response to a Sturmey Archer internal 3 speed axle .375 (10mm) that floats within the factory dropout that measures .480/.497 (14mm) the centering washers also measure .375 (10mm) thereby leaving the hub laying in the bottom of this dropout without any reasonable...
Pierce doing a few tasks ... the chainguard repair and reset the Sturmey Archer to grab low better. While removing the front fork to service the hub it was noticed that the truss plate attached to the front fork was coming apart internally. That said for the life of me I cannot determine what...
Pierce a few things ... first finally took the Texas Special on a significant ride and was even more pleased with the acceleration, handling, and some stopping power, anyway all good.
Second you had suggested to me that you were moving into 28" early bikes (I think) that said, I'd be...