It’s a bird

Rat Rod Bikes Bicycle Forum

Help Support Rat Rod Bikes Bicycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Some progress on the jig:
the bottom bracket centering worked out well. This is a better method than I’ve used in the past (many of which didn’t work out well.)
5E23BE96-0F62-42DD-9CA0-6E04BAD3109D.jpeg
40A53BF4-81FC-4F08-874D-14DA27DC8BAD.jpeg
6551ED69-6F8B-421D-A96A-BD879D997735.png

I usually just mount the headtube onto the fork for positioning to tack, similar to how the rear dropouts are mounted. So, that’ll be the easy route unless I come up with a more fosistocated method.
 
AFD0CA78-B27A-444E-8820-806591D05607.jpeg

Benefits of using hand tools:
1.) Slow progress means more spotting errors before they get away from you.
2.) None of that burnt-metal smell and mess.
3.) Warms you up in a cold garage.
4.) One arm gets a serious workout. :showingbiceps:

935D3DF2-1C0A-486E-AF7E-7E731CA51C9C.jpeg

70A5264E-05AA-474D-A011-63FA05FECC6B.jpeg

So I hope you can see what I’m doing here. The positioning may not be just right yet, but there ya go. Needs shaping on the back side , axle slot, and a fender mount hole.
 
Might want to rethink your fork dropouts. They don't appear to have enough room for the axle nuts and a wrench to tighten them.
 
Good point. I’ll look at my source ‘insirational’ material and see how that spacing works. Welding is probably a week or two away, anyway, so there’s time to tweak.
 
Well, as far as progress, I slotted the chain stays today, and they’ll sit nicely against the BB in the jig.
37330648-B648-4BEF-A74E-3926F106AA2D.jpeg


Also drilled & cut the front dropouts. They’re further back than originally drawn (black marker) and should work woth the nut. I’ll have to be sure the weld bead isn’t too big. Good I TIG. (rhyme time!:grin:)
(yes, you astute observers, that is a rear wheel. — a spare used for axle fit testing)
077FAAE0-D5A7-415F-B22A-E10504FE67E4.jpeg


Looking at the work schedule for the rest of the month, might not have much happening. March will be hectic if I want to push this through.
 
Well folks,
I'm gonna go ahead and throw in the towel on this one. I knew it was a long shot from the get-go, and looking at my work schedule, it just ain't gonna happen. I have a nice pile-o-tubes if time permits for the big BO this summer, or, as I usually say, I'll be smart and find an already assembled frame to turn into a bike! (and maybe actually finish!) Good luck to everyone, I'll be watching, and voting. :cool2:
 

Latest posts

Back
Top