Recent content by Jess Stevens

Plus the fact that the 1st low Tech way is the only one that I would feel comfortable undertaking by myself either of the other 2 ways I would be out of my depths for sure. I've never owned a single 3 pc bb and I dont weld lol. Then again I cant do the lathe part either so I'd have to...

Yeah that's great thanks guys it seems like a have several good options. The most low Tech way would be to drill a hole for the drive pin and Totally the way that makes the most sense Mechanically would be to convert to a 3 piece and use it with that. But as usual the most pain in the ... way...

I dont know if you never see it because it's such a pain in the ... to deal with the pins that people just take off the one side they have to or if they are permanently attached. I do not know Sent from my SM-G955U using Tapatalk

I I've never seen one separated from the Crank arm does anyone know if they do separate or would it literally have to be ground out. Sent from my SM-G955U using Tapatalk

Ya visually it seems very close at least. I havent had it removed yet. From what I read about dealing with cc's whatever it will cost will be money well spent. Just holding that dogleg up to it seems like it should fit in terms of radius but it may need to need to be a bit narrower or I could be...

Bump Sent from my SM-G955U using Tapatalk

Best case scrnario would be figure a way to make it work with this crank arm Sent from my SM-G955U using Tapatalk

I very much want to use this chain wheel. I dont think they came in chrome just SS. I want to have it chromed for my project bike. I would prefer if I could somehow get it to work within the standard 1 piece crank setup but may not be able to. Can I switch to a 3pc setup in my bb and then use...

Bump Sent from my SM-G955U using Tapatalk

More Sent from my SM-G955U using Tapatalk

All prices are including shipping to anywhere in mainland US. Union Schwinn Approved 4" Stingray/Cruiser Pedals $30 36h Black Out New Departure Rear CB Hub and Schwinn Script Front Hub - $60 S-W Western Flyer 26" Working Speedometer $40 Cadet 26 Speedo - Havent opened it up but needle doesnt...

The pics may be a bit confusing. The pics where there is no rust whatsoever are of the better one on the left. It has a lens. The other does not. Any picture that has any sort of rust whatsoever is the one on the right the one that would be for parts if needed. The one one the left does work...

Pics Sent from my SM-G955U using Tapatalk

60's Japan Lantern headlight and Turn Signal Taillights electrical works but switch is broken off at the point where it comeos out of the light turn signals could be wired to something else. Im gonna sell them together because its a project for someone better with electrical than I am. You'll...

Yes Sent from my SM-G955U using Tapatalk