A place for scratch built frame bikes.
my new project:
a swing-bike with a big wheel in the rear and other small details
I made with my bent tube
rear wheel was widened by me
Here are the first pictures
Last edited by champx on Fri Mar 02, 2012 7:48 pm, edited 2 times in total.
for the wheel,
you have to take a steel wheel like this:
not like that because it is a bad weld:
cut between the spoke holes with a small grinder placed on the floor, hold it firmly and turn the rim to get a straight cut
after simply rolling a sheet of good size and welded together the pieces of rim
looks really good so far, keep up the great work
one question tho, how r u planing on doing the hub for the rearwheel?
are you going to widen that aswell? and will it have brakes, gears, freewheeling etc?
check out my project:
Users browsing this forum: No registered users and 1 guest