~ Unusual ~ Kelly bars ~ > SOLD <

Discussion in 'FOR SALE' started by willswares1220, Jan 28, 2016.

  1. willswares1220

    willswares1220

    Joined:
    Feb 20, 2012
    Messages:
    46
    Location:
    Port Washington, Wisc. 53074
    > SOLD <

    These bars are different, rather than the usual "butterfly" type of Kelly bar. Set them up for that touring appearance / down for that low slung look as shown.
    They measure a wide 20-7/8 inches ( outside of grip end to grip end ) with a stem diameter of 7/8 inches.
    They are straight and solid with traces of original nickle plating and quite a bit of pitting as shown, but still have an interesting appearance for that original bicycle or would be great on that Rat Rod bike for that unique look!! :cool:
    The original nut and washer are missing as you can see. I had used the original, early stamped Kelly nut on a set of bars in a restoration I was working on. The nut I had used off of these bars was stamped ( Kelly Bar Pat'd April 19,98 )


    Pm's answered

    Port Washington, Wisc. 53074




    IMG_0073.JPG IMG_0059.JPG IMG_0051.JPG IMG_0046.JPG IMG_0045.JPG IMG_0012.JPG
     
    Last edited: Feb 12, 2016
    horsefarmer likes this.
  2. willswares1220

    willswares1220

    Joined:
    Feb 20, 2012
    Messages:
    46
    Location:
    Port Washington, Wisc. 53074
    IMG_0016.JPG IMG_0019.JPG IMG_0002.JPG IMG_0033.JPG IMG_0038.JPG IMG_0019.JPG IMG_0002.JPG IMG_0033.JPG IMG_0038.JPG
     
    Last edited: Jan 28, 2016
    horsefarmer likes this.
  3. deven_science

    deven_science

    Joined:
    Dec 8, 2011
    Messages:
    3,186
    Location:
    Sacramento, CA
    Those are dang fine looking bars. Too bad about the nut, and yeah, these aren't the butterfly bars I'm always on the hunt for. Still, if I was monied up, I would probably grab them. Man, there's a couple of things popped up today that I want.
     
    horsefarmer likes this.
  4. willswares1220

    willswares1220

    Joined:
    Feb 20, 2012
    Messages:
    46
    Location:
    Port Washington, Wisc. 53074
    ~~ Bump & discounted ~~:cool:
     
    Last edited: Feb 6, 2016
  5. willswares1220

    willswares1220

    Joined:
    Feb 20, 2012
    Messages:
    46
    Location:
    Port Washington, Wisc. 53074
  6. ozzmonaut

    ozzmonaut Pro Member

    Joined:
    Feb 9, 2011
    Messages:
    1,982
    Location:
    Mount Airy, NC (aka Mayberry)
    These are cool.Why aren't all handlebars adjustable? Especially now with all of the processes being easier to complete on a mass-production level. Anyways, the price is looking decent and you at least have my attention. I have not yet received the frame they would go on, so I can't choose a direction for the bike just yet.
     
  7. willswares1220

    willswares1220

    Joined:
    Feb 20, 2012
    Messages:
    46
    Location:
    Port Washington, Wisc. 53074
    ( 2/12/16 ) Still available at $150.00 shipped
     

Share This Page